Difference between revisions of "DsPic-Raspberry programmer interface"
| Line 74: | Line 74: | ||
<br>Bash file @ /etc/rc.local<br/> | <br>Bash file @ /etc/rc.local<br/> | ||
<pre> | <pre> | ||
| − | #The following lines should be added to file to allow the pic to run after RPI boot | + | #The following lines should be added to file rc.local to allow the pic to run after RPI boot |
#The wiringpi package needs to be installed | #The wiringpi package needs to be installed | ||
gpio -g mode 5 down | gpio -g mode 5 down | ||
Revision as of 21:04, 13 May 2020
dsPic-Raspberry programmer interface
A general purpose interface consisting in two opto-couplers have been developed to program the dsPic micro-controllers directly from the Raspberry, allowing remote maintenance and reprogramming of each de-localized unit.
It as to be powered by 12 V (minimum voltage 10.5V - maximum voltage 13.5V) dsPic node unregulated Vcc and feed by the Raspberry GP_I/O, with a common digital ground.
Pin-out and connections
The following table describes the pin-out assembly of the opt-programmer developed to be used with picpgm software.
| Programmer pin-out | |||||
|---|---|---|---|---|---|
| Rasp I/O | Label | Programmer I/O | Picpgm function (invert) | Cable | |
| 39 | GND | GND | - | Blue/Wh | |
| 37 | BCM26 | PGD1//470 | DIN (0) | Brown | |
| 35 | BCM19 | PGD2//470 | DOUT (0) | Blue | |
| 33 | BCM13 | PGC | CLK (0) | Green | |
| 29 | BCM5 | RST (when high) | MCLR (1) | Brown/Wh | |
| 03 | BCM2 | PGMmode (high) | PGM (0) | Orange | |
If RST low and PGMmode high the pic enter program mode (12V @ MCLR). If RST high (PGMmode any but should be low) the pic reset and hold. If PGMmode low and RST low the pic run with MCLR at high impedance (or pulled up from dsPicnode side.
PGD1 and PDG2 are summed with two 470 ohm resistors to the pic PGD PGC is connected to the pic PGC with one series resistor of 470 ohm.
The 12V pull-up is wired with a 100 Ohm resistor (version 1) and 470 ohm (original version). This is a non-essential situation as it was devised to create 4.3V if PGMmode and RST were independent.
The Picpgm column shows how to set the Picpgm configuration file in order to use this programmer with the GPIO's shown on the table. It also shows if the invert option should be selected for each of them.
Software use
The picpgm software is hosted here and should be used with the following script:
Bash file @ /etc/rc.local
#The following lines should be added to file rc.local to allow the pic to run after RPI boot #The wiringpi package needs to be installed gpio -g mode 5 down gpio -g mode 2 down
A backup is also founded at elab1/...
